Building Color Steel 720 Floor Deck Forming Machine
The product floor (steel deck, construction profile steel plate)
produced by "Building color steel 720 floor deck forming machine"
is made of galvanized steel sheet rolled and cold-formed, and the
cross section is V-shaped, U-shaped, and trapezoidal. Or similar
type of waveform.
The "Building color steel 720 floor deck forming machine" is mainly
used as a template, but it can also be used for other purposes.
The construction sequence of "Building color steel 720 floor deck
forming machine" concrete composite structure:
1. The surface of the steel beam is smooth and clean, and the steel
bottom plate is welded to the steel beam according to the plan;
2. According to the welding procedure, weld the load-bearing plate
to the steel beam;
3. Fix the retaining ring between the diamond bearing plates with
clips;
4. Use a welding gun to fix the scissors on the composite wind
harness;
5. Fasten the steel mesh according to the design requirements;
6. Pouring concrete.
Features of the steel floor deck produced by "Building color steel
720 floor deck forming machine":
1. "Building color steel 720 floor deck forming machine" replaces
the traditional formwork and makes up for the shortcomings of the
traditional formwork;
2. "Building color steel 720 floor deck forming machine", with
simple structure, fast and easy to assemble;
3. "Building color steel 720 floor deck forming machine" has light
weight, high strength, large bearing capacity and good seismic
resistance;
Main parameters of Building Color Steel 720 Floor Deck Forming Machine
| Material |
| Material Thickness(&):0.5-1.0mm |
| Applicable material:Galvanized Steel Coils,Cold Rolled Coils,yield
strength 245Mpa or 550Mpa |
| Machine Components |
| 1)Manual Decoiler: one set |
| Max. feeding width: 500mm, coil ID range 470mm±30mm |
| Capacity: Max. 3Ton |
| 2) Cold Rolling Mills: |
| Rollers manufactured from bearing steel GCr15,precision
machined,hard Chrome Coated with thickness 0.04mm(for longer life
and anti-rust) ; |
| Motor Driving,Gear chain transmission, 22 forming stations and 7
rollers(3 upper rollers and 4down rollers)for straightening and
levelling) |
| Main Motor=15KW , Frequency speed control |
| Forming speed approx.12-18m/min |
| 3)Hydraulic Cutting device |
| hydraulic motor: 4KW, Hydraulic pressure range: 0-12Mpa |
| Cutting tool material: Cr12, Heat treatment |
| 4)PLC Control System(Touch screen brand:Taiwan WEINVIEW,Inverter
brand:Finland VOCAN/Denmark Danfoss ,Encoder brand: Japan Koyo) |
| Control the quantity and cutting length automatically |
| Combined with: PLC, Inverter, Touch Screen, Encoder, etc |
| Cut-to-length tolerance≤±1mm |
| Control Voltage 24V |
| 5) Exit Rack Un-powered, two units |
